Ford Ranger Wildtrak/Raptor (2012-Current) Roll Top Slimline II “Digger” Pack by Frontrunner

In stock Ford Ranger Wildtrak/Raptor (2012-Current) Roll Top Slimline II “Digger” Pack by Frontrunner. Available in Australia from the official Front Runner stockist My Generator.

Ford Ranger Wildtrak/Raptor (2012-Current) Roll Top Slimline II ""Digger"" Pack by Frontrunner, Limited Lifetime Warranty

Pack Includes:

Ford Ranger Wildtrak (2012-Current) Roll Top Slimline II Load Bed Rack Kit – by Front Runner, KRRT016T
Ratcheting Spade/Shovel & Paddle Mount – by Front Runner, RRAC024
Recovery Device & Gear Holding Side Brackets – by Front Runner, RRAC103

Ford Ranger Wildtrak (2014-Current) Roll Top Slimline II Load Bed Rack Kit – by Front Runner.

This kit creates a full-size rack that sits above your Ford Ranger Wildtrak's load bed when fitted with a Roll Top Cover. This Slimline II cargo carrying rack kit contains the Slimline II tray (1425mm x 1156mm) and 6 Pickup Roll Top Leg Mounts that fit into the existing factory/OEM tracks in your Roll Top Cover.

All Front Runner Rack Kits contain installation instructions as well as all the components needed to mount the Slimline II Tray to your vehicle.

Note : If your Roll Top extrusion has a 6mm (0.24"") to 7mm (0.28"") slot opening, you may need Track Mount Stud Plate for installation.

The t-slots on the tops and bottoms of the rack tray slats and edge profiles accommodate standard 8mm bolts.

To determine the approximate height from your vehicles roof to the top of your Slimline II Roof Rack, add the height of the Slimline II Tray (50mm/2"") to the height of the Foot or Grab-on Foot listed above.

If your Slimline II Roof Rack kit uses Legs, add the height of the Slimline II Tray (50mm/2"") to the height of the Legs to determine the height of the rack from your vehicle's rain gutters.

If your Slimline II Roof Rack kit uses Foot Rails, add the height of the Slimline II Tray (50mm/2"") to the height of the Foot Rails to determine the height of the rack from the crown (highest point) of the vehicles roof.

Installation Instructions for LASS028

Installation Instructions for RRSTJ06

Ratcheting Spade/Shovel & Paddle Mount – by Front Runner.

Mount a spade/shovel or similar gear up and out of the way on the side of a Front Runner Roof Rack.
These brackets install along the Slimline II Roof Rack Tray side rails in minutes. No drilling required.
Can accommodate most shovel sizes and is adjustable to fit gear 1/2"" (12mm) to 2"" (50mm) in diameter.

Consists of:

2x Spade/Shovel Bracket
2x Ratchet buckle
2x Ladder Strap
1x Nut and bolt kit

Brand Front Runner
SKU KRRT016T_BUNDLE_3
Stockist My Generator